This section indicates the power measured for all power rails when system is in Standby state. This Linux kernel change “ARM: Note that while many of these configurations are accomplished in the source code corresponding to each ASoC layer, some are also done the Device Tree. The following table list the various device drivers supported and the device they are supported on. The commit for this change in Linux stable tree is d patch.

Uploader: Zull
Date Added: 8 February 2018
File Size: 9.69 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 84852
Price: Free* [*Free Regsitration Required]

It also provides the typical power consumption measurement observed for different scenarios. Test setup is available here.

The commit for this change in Linux stable tree is a9c8f11 patch. Please refer to hardware documentation for list of all supported boot modes. The measurements were done using EVM revision 1. Add amx-bonegreen” is included in the Linux 4. Performance benchmarks were collected using the Iperf tool and aiic3106 options were used to collect the throughput numbers. This page was last modified on 28 Juneat The commit for this change in Linux stable tree is a96e patch.

The commit for this change in Linux stable tree is a8d3b59 patch. The commit for this change in Linux stable tree is ee patch. This section provides an overview of the Ethernet driver features along with throughput and CPU load numbers. The full device tree file can be kinux here: Content is no longer aif3106 and is being kept for reference only!

New Drivers  LEXMARK 1150 PRINTER DRIVERS DOWNLOAD

Posts on Linux 4.4

Gets device parameters from the UART example, port type, port num, baud rate, base divisor, and so on. The storage media is formatted as vfat filesystem. The commit for this change in Linux stable tree is 27f39e5 patch.

Ethernet driver follows standard Linux network interface architecture. The commit for this change in Linux stable tree is 48aff9f patch.

[alsa-devel] AIC3106 problem with driver (MIC BIAS)

For technical support please post your questions at http: They are as follows:. Enable pcf 0x26 address on i2c2 bus” is included in the Linux 4. The MMC driver is implemented as a block driver. If you are a TI Employee and require Edit ability please contact x from the company directory.

This is an aaic3106 to save power. Enable analog audio support The […]. Note that while many of these configurations are accomplished in the source code corresponding to each ASoC layer, some are also done the Device Tree. This section indicates the power measured for all power rails when system is in suspended state via suspend-to-ram.

New Drivers  KU-0453 ZBOARD DOWNLOAD DRIVER

The commit for this change in Linux stable tree is 6ddd5fc patch. This section indicates the power measured for all qic3106 rails at various OPPs selected via cpufreq. If you are a TI Employee and require Edit ability please contact x from the company directory.

Measurements were taken while Linux was idle at command prompt.

Sitara Linux Audio Porting Guide – Texas Instruments Wiki

Hot linix scripts in the filesystem mount removable media in sync mode to ensure data integrity. Default timeout of this driver is 60 seconds. The commit for this change in Linux stable tree is 4fbdc6a patch. This chapter describes the SPI flash driver architecture, driver features and performance numbers throughput and CPU load.